NEC MultiSync XG110LC

107
When using with two or more ISS-6020/ISS-6020G Switchers:
1) Use the CURSOR or button to select “INPUT” and press
ENTER.
• The “MASTER” and “SLAVE” menu will be displayed.
2) Use the CURSOR or button to select the input slot
number of the master Switcher from the “MASTER” menu
and press ENTER.
3) Use the CURSOR or button to select the input slot
number of the slave Switcher from the “SLAVE” menu and
press ENTER.
• The “TIME” input screen will be displayed.
4) Enter the starting time using INPUT buttons and press
ENTER.
• Type the time in hours (24 hours), minutes, and seconds.
• If you have made an error in the input of numbers, press the
END button to return to the “SLAVE” menu then start from
step 2).
• The “WEEK SELECT” screen will appear.
5) Use the CURSOR or button to select any day of the
week, then select either “YES” or “NO” with ENTER.
• When “DAILY” selected, the entire week is changed to
“YES”.
• When “END” is selected, the current setting is saved.
• To return to Step 4), press the END button. In that case, the
changed setting is invalid.
NOTE: Typing 99:99:99 in the time input menu will execute the
program immediately. (See the example in the following “WAIT”
section.)
INPUT
WAIT
GOTO
LOOP
P-ON
P-OFF
INSERT
DELETE
SLOT–01
SLOT–02
SLOT–03
SLOT–04
SLOT–05
SLOT–06
SLOT–07
SLOT–08
SLOT–09
SLOT–10
MASTER
SLOT–01
SLOT–02
SLOT–03
SLOT–04
SLOT–05
SLOT–06
SLOT–07
SLOT–08
SLOT–09
SLOT–10
MASTER
SLOT–01
SLOT–02
SLOT–03
SLOT–04
SLOT–05
SLOT–06
SLOT–07
SLOT–08
SLOT–09
SLOT–10
SLAVE
TIME __:__:__
DAILY
SUN
MON
TUE
WEN
THU
FRI
SAT
END
WEEK SELECT

NO
YES
YES
YES
YES
YES
NO
SETTING