40
ADJUSTMENT
RETURN USER MODE?
YES NO
7 Repeat steps 4 to 6 for the other CRTs if necessary.
8 To end this adjustment, press the END button.
• Whenever the END button is pressed, the menu will sequence
in this order:
“FOCUS” menu → “ADJUST” menu → Source screen
• If the “RETURN USER MODE?” menu appears, use the
CURSOR or button to select either “YES” or “NO” and
then press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode the next
time, you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode the next
time, you will not need to re-enter your passcode.
NOTE: The center focus for the Blue CRT is pre-adjusted so that
the best white uniformity can be obtained at the gauge center
(0%). For this reason, it has been set at the factory to be
slightly out of focus.
Therefore you should not perform the center focus adjustment
to the Blue CRT with the remote control.
To Next Page
Loading...
Need help?
General