44
ADJUSTMENT
4) For alignment, hold down the CTL button, then use the
CURSOR buttons to align the pattern. For convergence, hold
down the CTL button and then use the CURSOR buttons to
align the Red or Blue pattern with the Green pattern.
When you have another adjustment point next to the
current one, press and hold down CTL and press
to correct the horizontal line.
When you don't have another adjustment point
next to the current one, press and hold down CTL
and press to correct the horizontal line on the left
adjustment point
: current adjustment point
: next adjustment point
Example: when correcting the horizontal line
NOTE: For more accurate convergence correction on edges,
perform the amplitude and linearity adjustments before the
POINT convergence adjustment.
RETURN USER MODE?
YES NO
6 To end this adjustment, press the END button.
• Whenever the END button is pressed, the menus will sequence
in this order:
“ALIGNMENT” menu → “ADJUST” menu → Source screen
• If the “RETURN USER MODE?” menu appears, use the
CURSOR or button to select either “YES” or “NO” and
then press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode again,
you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode again,
you will not need to re-enter your passcode.
To Next Page
Loading...
Need help?
General