110
SETTING
m Selecting “P-ON”
1) Use the CURSOR or button to select “P-ON” and press
ENTER.
• The POWER ON input screen will be displayed.
2) Enter the POWER ON TIME you wish to turn on the projec-
tor using INPUT buttons and press ENTER.
• Type the time in hours (24 hours), minutes and seconds.
• If you made an error, press END to return to the Program
menu, then start again.
NOTE 1: Typing 99:99:99 in the time input menu will execute
the program immediately.
NOTE 2: The P-ON command is available only when the
projector is off (in the standby condition).
The P-ON command is ignored if set in the first line. In this
case, the program will start its execution from the second line.
m Selecting “P-OFF”
1) Use the CURSOR or button to select “P-OFF” and press
ENTER.
• The POWER OFF input screen will be displayed.
2) Enter the POWER OFF TIME you wish to turn on the
projector using INPUT buttons and press ENTER.
• Type the time in hours (24 hours), minutes and seconds.
• If you made an error, press END to return to the Program
menu, then start again.
NOTE: Typing 99:99:99 in the time input menu will execute the
program immediately. (See the example in the “WAIT” section
on page 108)
INPUT
WAIT
GOTO
LOOP
P-ON
P-OFF
INSERT
DELETE
TIME __:__:__
INPUT
WAIT
GOTO
LOOP
P-ON
P-OFF
INSERT
DELETE
TIME __:__:__
To Next Page
Loading...
Need help?
General