NEC NP-UM330W - Page 16

ENG-14
ENG-15
InstallingtheMacsoftware
1. LoadtheCD-ROMintothecomputer.
2. DoubleclicktheCD-ROMicon.
3. Doubleclick“eBeamEducationSuite.pkg”.
4. Followtheinstructionsthatappearonthescreen.
7. Launch the software and perform calibration.
1. When the software is started for the rst time, a conrmation message will be dis-
played.
To calibrate it now, click “Yes”.
2. Tapthetargetsdisplayedonthescreenwiththestyluspen.
Using the stylus pen, tap the center of the target when highlighted.
You can now use your stylus pen as a mouse.
Press the ESC key to suspend calibration.
YoucanstartthesoftwarenexttimebyclickingtheeBeamInteractiveiconontheDesktopor
Taskbar.
Tochangeyourcalibrationdata,select[CalibrateInteractiveArea...].
For details, refer to the software’s help file.
NOTE
This product was developed for use with the NEC projector. Because of this, there are some dif-
ferences in the eBeam Interactive online help. The help file refers to “mouse insert” or “interactive
stylus” instead of “stylus pen”. Replace these terms with “stylus pen”