NEC NP-UM330W - Setup Procedure

ENG-8
ENG-9
Setup Procedure
Setup Flow
1. Mountthesensorunittotheprojector.
2. Connecttheprojectortothecomputer.
3. Turnontheprojectorpowerandadjustthepositionandfocusoftheprojected
image.
4. LoadtheAAAbatteryinthestyluspen.
5. ConnectthecomputerandsensorunitwiththeincludedUSBcable.
6. UsetheincludedCD-ROMtoinstalltheapplicationontothecomputer.
7. Launchthesoftwareandperformcalibration.
1. Mount the sensor unit onto the projector.
1. Openthescrewcoveratthecenterofthesensorunit.
2. Attachthesensorunittothetwonooksinthescreensidesurfaceoftheprojector.