NEC NP-V260 Installation Guide

NEC Display Solutions of America, Inc.
V260/V260X/V300X Installation Guide
Ceiling Mounted and Desktop Rev 1.0
www.necdisplay.com V260/V260X/ V300X Page 1 of 6
Contents
Product Description, Lens Specs, Notes and Formulas Pg 1
Diagrams & Distance Charts
Pg 2
Cabinet Dimensions
Pg 3-4
Ceiling Mount Dimensions
Pg 5
Input Panels and Control Codes
Pg 6
Product Description
Type: 1-chip DLP projector, Brightness: V260/V260X: 2600 Lumens
0.55” DLP V300X : 3000 Lumens
Résolution: V260: 800 x 600 Fan Noise: V260/V260X: 34dB / 31dB @ 1 meter
V260X/V300X: 1024 x 768 V300X : 37dB / 33dB @ 1 meter
Dimensions: 12.2” (W) x 3.7” (H) x 9.7” (D) Weight: 5.5 lbs
Power Consumption: V260/V260X: 242W (max) BTU’s: V260/V260X: 825 BTU/hour
V300X: 278W (max) V300X: 948 BTU/hour
Lens Specifications
Throw Ratio: 1.9 – 2.1:1 (for 100” diagonal) Focal Length: 21.8mm – 24.0mm
Offset Angle: 12.8° - 14.0° (for 100” diagonal) F/#: 2.41 - 2.55
Screen Sizes: 30” - 300” diagonal (4:3) Manual Focus/Manual Zoom
Notes
 For screen sizes not indicated on the projection tables, use the formulas below.
If the figures on the tables do not match the results of formulas, use the figures in the table.
 All calculations are based on a 4:3 aspect ratio.
 Distances are in inches, for millimeters multiply by 25.4.
 Distances may vary 5%.
Formulas
The Projection Formulas use the image width for calculation. For proper projection placement, determine the image width
for the desired screen size. Use the Screen Formulas below to calculate all screen dimensions. Plug in the width for “W” in
the Projection Formulas.
Refer to the diagrams and charts for popular screen sizes on page 2:
Definitions: 4:3 Screen Formulas:
W = Image Width W = H x 4/3
H = Image Height (size) H = W x 3/4
B = Vertical distance between lens center and screen center Screen Diagonal = W x 5/4
C = Throw distance
D = Vertical distance between lens center and screen top
(screen bottom for desktop application)
Projection Formulas:
B = 0.487W
C (wide) = 1.94W
C (tele) = 2.165W
D = 0.112W
α (wide) = tan¯¹ (B/C(wide))
α (tele) = tan¯¹ (B/C(tele))

NEC NP-V260 Specifications

General

Native aspect ratio	4:3
Projection distance	1.2 - 13 m
Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	DLP
Contrast ratio (typical)	2000:1
Screen size compatibility	33 - 300 \
Projector native resolution	SVGA (800x600)
Keystone correction, vertical	-40 - 40 °
Focus	Manual
Throw ratio	1.95 - 2.15:1
Zoom capability	Yes
Focal length range	21.83 - 24 mm
RS-232 ports	1
Maximum analog resolution	1920 x 1080 pixels
Lamp type	AC HID
Lamp power	180 W
Light source type	Lamp
Service life of light source	3500 h
Service life of light source (economic mode)	5000 h
DVI port	No
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in	0
Supported video modes	1080i, 480p, 576i, 576p, 720p
Analog signal format system	NTSC 4.43, PAL, PAL L, PAL M, SECAM
Supported graphics resolutions	1024 x 768 (XGA), 1280 x 1024 (SXGA), 1360 x 768 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 1600 x 1200 (UXGA), 800 x 600 (SVGA)
RMS rated power	7 W
Placement	Ceiling
Product type	Standard throw projector
Product color	White
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	233 W
Power consumption (standby)	4 W
Power consumption (PowerSave)	0.5 W
Power consumption (economy mode)	210 W
Noise level	34 dB
Certification	CE; ErP; ÜV GS
Noise level (economic mode)	31 dB
Storage temperature (T-T)	-20 - 50 °C
Operating temperature (T-T)	5 - 40 °C
Cables included	AC, VGA
Remote control type	IR
Sustainability certificates	RoHS

Weight and Dimensions

Depth	247 mm
Width	310 mm
Height	95 mm
Weight	2500 g