99
6. Using On-Screen Menu
no-signal area
Selecting Aspect Ratio and Position for Screen [SCREEN]
SCREEN TYPE ....... Select one of two options: 4:3 SCREEN or WIDE SCREEN for the screen to be used. See also [ASPECT
RATIO].
(
→
page
84)
POSITION
.............. This feature allows you to adjust the vertical position of the image when WIDE SCREEN has been selected
for the screen type.
When WIDE SCREEN has been selected there is no-signal area above and below the image.
NOTE: This option is available only when [WIDE SCREEN] is selected in [SCREEN TYPE].
NOTE:
• After changing the screen type, check the setting of [ASPECT RATIO
] in the menu. (
→
page 84)
• [POSITION
] is not available when [4:3 SCREEN] is selected for [SCREEN TYPE] or when [LETTERBOX] is selected for [ASPECT
RATIO
].
(not available
on NP3151W)
Downloaded From projector-manual.com NEC Manuals
To Next Page
Loading...
