THE FUNCTIONS OF THE CONTROL PANEL
Used to adjust the amount of water according to the size of the load to be
washed.
Used to select the full automatic course:
Wool Speedy Gentle Standard Heavy
• Used to choose water temperature being supplied.
• As the button is pressed; the water temperature will change between.
COLD – COLD + HOT - HOT
• In the case of a single valve model, there is no wash temperature
selector function.
• Used to pre-engage time for wash.
• If you want to change wash times, rinse times or spin times, you must
press this button after selecting each cycle by the cycle button.
Press the ‘Process’ button to choose a different mode combination.
1. Wash + Rinse + Spin (default option)
2. Soak + Wash + Rinse + Spin
3. Wash
4. Spin
5. Wash + Rinse
6. Rinse + Spin
• When you want to change a course during operation;
press the "START/PAUSE" button - select the course that you want to
change - press the "START/PAUSE" button again.
• Press this switch to turn the power on or off.
To Next Page
Loading...
