To Next Page

To Previous Page

NEC PowerMate ML5 Disassembly Manual

Page 5

Removing the Stabilisers

To remove the stabilisers follow the next steps:

1. Place the computer body with the bottom side protruding a little away from the edge of a

table.

2. Free the locks C and slice the stabilisers as indicated by the arrows A and B, towards the

front of the system for stabiliser A and towards the rear for stabiliser B,.

Fig. 1: Removing the stabilisers

Opening the Chassis

To open the chassis, first remove the stabilisers (see Removing the Stabilisers), then follow

the next steps:

1. Put the chassis in horizontal position, rear side towards you.

2. Unlock the two cover locks shown in the picture below.

Fig. 2: Unlocking the cover of the chassis

3. Slide the cover towards the front of the chassis a few centimetres, then carefully lift the

cover away from the system and set it aside.

Questions and Answers:

Need help?

Do you have a question about the NEC PowerMate ML5 and is the answer not in the manual?

NEC PowerMate ML5 Specifications

General