NEC SL1000 - Placing Calls; Outside Call - Quick Access; Outside Call - Access by Code; Intercom Call - Dial Access

-5 -
 Place an Outside Call <Access by Code>
Placin
g
Calls
 Listen for Dial Tone before dialing a Telephone Number.
 You can have function keys for Trunks or Trunk Groups. Ask your NEC Authorized Supplier.
 To change Trunk Access Code, Ask your NEC Authorized Supplier for details.
 Listen for Dial Tone before dialing a Telephone Number.
 In case the number of Trunk Group is more than 10, you should enter 2 digits (e.g. 11 : Group 11) after
dialing “804”. Ask your NEC Authorized Supplier for more details.
 For the dial digit of Trunk Number, Ask your NEC Authorized Supplier for details.
 Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear a beep, begin
speaking. Dialing “1” changes voice/ring mode. (in case the destination is Multi-line Telephone)
 Place an Outside Call <Quick Access>
 Place an Intercom Call <Dial Access>
Trunk Key
Telephone Number
? ? ? ?
Trunk No. (e.g. Trunk 5)
Trunk Group No.
Telephone Number
Speake
r
9
8 0 4 ?
# 9 0 5
? ? ? ?
?
Extension Number
Speake
r
? ? ?
Trunk Access Code