To dial a System Speed dialing number:
1. Press the Speaker key.
2. Dial #2 (default Service Code) OR press the Redial Key OR Press the System
Speed Dialing key.
3. Dial the Station Speed Dial buffer number (Default: 000~999).
8
MICROPHONE CONTROL
1. Press the MIC key. A lit MIC LED indicates that the MIC is on.
SPEAKERPHONE CALLS
1. Press the Speaker key and the LED lights.
2. Ensure that the MIC LED is lit.
3. Place internal or outside call.
4. Converse.
5. Press the Speaker key to disconnect call.
Note: The handset may be used at any time during the conversation. To resume
handsfree operation or to monitor a call, press the Speaker key (the LED lights) and
replace the handset.
GROUP LISTENING
To initiate Group Listening:
1. Place or answer call using the handset.
2. Press Speaker twice (but do not hang up). Note: Speaker flashes slowly.
Note: You can talk to the caller through your handset. Your coworkers hear your
caller’s voice over your telephone’s speaker.
Note: When you press Speaker once, you turn your Speakerphone on. The second
press turns on Group Listen. Pressing the Speaker key a third time cancels the Group
Listening feature.
10
HOLDING CALLS
Note 1: To retrieve a held call, press the flashing Line key or Conf key (internal calls).
Note 2: Calls on System Hold can be retrieved from any multiline telephone with the
held line appearance.
Note 3: After a preprogrammed time, the held call will recall to the originating
station.
TRANSFERRING CALLS
With a call in progress:
1. Press the Transfer key.
2. Dial the station number.
3. Announce the call (optional).
4. Replace the handset.
Note 1: If the called station is busy, replace the handset to initiate a camp-on.
To Next Page
Loading...
Need help?
General