NEC U250X - Cleaning the Filter

60
English ...
Appendices
Cleaning the Filter
The air-lter sponge keeps dust and dirt from getting inside
the projector and should be frequently cleaned. If the lter is
dirty or clogged, your projector may overheat.
The message for lter
cleaning will be dis-
played for one minute
when the projector is
turned on or off.
To cancel the message,
press any button on
the projector cabinet
or the remote control.
CAUTION:
• Turn off the projector, and unplug the projector before replacing the lter.
• Only clean the outside of the lter cover with a vacuum cleaner.
• Do not attempt to operate the projector without the lter cover.
To replace the lter
CAUTION:
• Before replacing the lter, remove dust and dirt from the projector cabinet.
• The projector contains high-precision parts. Keep out dust and dirt during lter
replacement.
• Do not wash the lter with water. Water will damage the lter membrane.
• Reattach the lter cover correctly. Failure to do so may cause projector malfunc-
tion.
To clean the air-lter
Use a small vacuum cleaner
designed for computers and
other ofce equipment.
If the dirt is difcult to re-
move or the lter is broken,
please contact your local
dealer or service center to
obtain a new lter.
Replacing Procedure:
1. Disconnect the power cord.
2. Pull the lter out.
3. Replace the lter.
4. Install the new lter by reversing the
previous steps.
5 After replacing the lter, turn on the
power, and press the [MENU] button
-> OPTIONS | Lamp Settings -> Clear
Filter Usage Hours to reset the lter
usage hours. Refer to page 52.