4 NEC Australia
1 - Call Indicator Lamps
Lamp at top corner of handset flashes when a call
terminates to the terminal. The Lamp lights steadily when
a message has been left.
2 – Soft Keys
These keys change function depending on what you are
doing with the phone. Their function is shown on the
phone’s screen above.
3 - Programmable Keys
These keys can be programmed as either Flexible Line
key, Programmable Feature key or One-Touch Speed Dial
key.
4 - Recall
Press this key to terminate current call and get dial tone.
5 - Feature
Used to activate terminal setup functions and to program
One-Touch keys.
Feature + 1 Turns microphone On/Off.
Feature + 7 Indicator On/Off. Controls if lamp flashes when
ringing.
Feature + 8 Direct/Pre-set dial pad selection.
Direct will automatically go off-hook when a
number is dialled. Pre-set will allow the number
to be dialled before going off-hook.
6 - Answer
When the LED on this key is flashing, press the key to
answer a waiting call.
7 - Mic
Press key to enable / disable your microphone in a hands-
free conversation. The key lights up if your microphone is
enabled.
8 - Menu
Access phone settings.
9 - Hold
Press this key to put a call on hold.
10 - Transfer
Allows the extension user to transfer a call or make a
second call.
11 - Speaker
Controls built-in speaker, which can be used for Hands
Free Dialling. The key lights when speaker mode is active.
12 - Redial
Press this key to activate the redial feature.
13 - Up / Down
Used to adjust speaker/receiver volume and ringer
volume.
Press while idle to adjust speaker/receiver volume.
Press while ringing to adjust ring volume.
Press while in a menu to navigate
14 - Enter
Press key to select menu items.
15 - Directory
Press key to activate speed calling (if enabled).
UNIVERGE SV9500 | DT820 6 Button IP phone Reference Sheet 1
UNIVERGE SV9500
DT820 6 Button IP phone Reference Sheet
Make a call
Lift the handset or press Speaker.
Dial the required number (For external calls, dial “0”
first).
Hang up on a call
Simply replace the handset or press Speaker if in
hands-free mode.
Hold a call
Ask the caller to please hold:
Press the Hold key.
You may replace the handset if you wish.
To retrieve a call:
Lift the handset.
Press the flashing line.
Note:
For exclusive hold - press Hold twice.
To Next Page
Need help?
General
