NEC Univerge UM8000 - Setting up the UCD Hunt Group

UM8000 Issue No. 1.0
Installation Manual 8 - 3
2.4 Setting Up the UCD Hunt Group
1. Create a phantom extension number that will be the UCD pilot (master)
number.
2. Link the UCD pilot number to the first digital voice messaging extension.
3. Link the first digital voice messaging extension number to the second
digital voice messaging extension number, the second to the third, and so
on.
Command Code: 11
First Data: xxx
Where <xxx> is an unused port
number.
Second Data: xxx
Where <xxx> is the UCD pilot
extension
Command Code: 170
First Data: xxx
Where <xxx> is the UCD pilot
extension number.
Second Data: xxx
Where <xxx> is the first digital voice
messaging extension number.
Command Code: 170
First Data: xxx
Where <xxx> is the first digital voice
messaging extension number.
Second Data: xxx
Where <xxx> is the second digital
voice messaging extension number.
NOTE
 Repeat this command, chaining each voice messaging extension to the next
voice messaging extension. When you reach the last voice messaging
extension number, link it back to the UCD pilot extension number created in
Create a phantom extension number that will be the UCD pilot
(master) number. (page 8-3).