©2018 NEC Display Solutions, Ltd. Page 26 of 71
f. Select SERVICE MENU.
g. Select SETTING LOCK and then select OFF.
h. Enter the passcode. The default is 0 0 0 0.
i. Select USB BOOT MODE and then select ENABLE.
j. It is also recommended setting SHUTDOWN SIGNAL to DISABLE and WDT to DISABLE
during programming.
k. Exit two levels and navigate to the POWER item on the COMPUTE MODULE menu.
l. Select POWER SUPPLY and then select ON.
Important: If the display goes into standby mode or Compute Module is powered off and on,
it will automatically cancel USB BOOT MODE. Be sure to check that the boot mode is as
intended if the process needs to be restarted.
4. Run the Win32DiskImager or Etcher tool and select the downloaded OS .img file.
If using Etcher:
a. Launch the Etcher application.
b. Select the downloaded OS .img file as the source image.
c. The Compute Module should automatically appear as the destination drive.
To Next Page
Loading...
