©2018 NEC Display Solutions, Ltd. Page 51 of 71
8.17 Expert menu Compute Module CM Fan Power
Available options: Auto / On / Off
Selects the operating mode of the Compute Module cooling fan.
• Auto (Default) - The display automatically turns the cooling fan on and off when the Compute
Module is powered on and off.
• Off - Immediately turns the cooling fan off. The fan will remain off even when power to the
Compute Module is turned on.
• On - Immediately turns the cooling fan on. The fan will remain on even when power to the
Compute Module is turned off.
This setting is available via the Expert menu and as a command to the display (OpCode 0x11B5).
6
8.18 Expert menu Compute Module CM Auto Shutdown
Available options: Enable / Disable
Selects how power to the Compute Module is handled when the display is turned off.
• Enable – When the display is turned off, power to the Compute Module will also be turned off. If
SHUTDOWN SIGNAL is enabled, this will be performed first to allow the system to gracefully
shut down before power is removed.
• Disable (Default) – Power to the Compute Module will remain on even when the display is
turned off.
This setting is available via the Expert menu and as a command to the display (OpCode 0x11B7).
6
6
These models require display firmware version R1.7 or later for this feature: P404, P484, P554, V404, V484, V554,
V404-T, V484-T, V554-T
To Next Page
Loading...
