NEC V864Q - To Rotate the Screen Image to Portrait Orientation; To Enable Support for the IR Remote Receiver Using Lirc

©2018 NEC Display Solutions, Ltd. Page 34 of 71
Select: A1 Overscan
Select: No
Or
• Edit the config.txt file to disable overscan:
sudo nano /boot/config.txt
Look for the following section:
# uncomment this if your display has a black border of unused pixels
visible
# and your display can output without overscan
#disable_overscan=1
Edit the last line to remove the #.
disable_overscan=1
Save the file and reboot.
7.3 To rotate the screen image to portrait orientation
Edit the config.txt file:
sudo nano /boot/config.txt
Add a new line:
display_rotate=3
Save the file and reboot.
7.4 To enable support for the IR Remote receiver using “lirc”
1. Make sure the display support is enabled.
a. On the NEC display select the COMPUTE MODULE video input.
a