20
Connecting the AC Adaptor
Connect the AC adaptor as follows:
1. Connect the AC adaptor cable into the power port on the notebook.
2. Plug one AC adaptor cable into the adaptor.
3. Connect the AC adaptor cable to grounded 100- or 240-volt, 50- or 60-Hz AC power outlet.
Caution
• Do not cover or place objects on the AC adaptor. Keeping the adaptor clear of objects lets
the adaptor cool properly during use.
• Only use the AC adaptor that comes with your notebook. Although other adaptors look
similar, using them can damage your notebook.
Powering The Notebook On and Off
To power on, locate the power button (or switch) and press or switch it on.
Caution
This equipment uses an ungrounded power cable. Replace the cord if it becomes damaged. The
cord must be rated for at least 250VAC at 10 amps, and must indicate international safety
agency approval. The plug must be a type appropriate for the country where it is used. Check
with your local dealer for HAR (Harmonisation certification mark) type 18 AWG (American Wire
Gauge), 2 conductor cord, or better. Obtain replacement cords at an authorised service centre.
The replacement must be of the same type and voltage rating as of the original cord.
To Next Page
Loading...
