NEC VT695 Placement Recommendations Guide

NEC Display Solutions of America, Inc.
Whitepaper
Projector Placement Comparison Ver. 2.4
www.necdisplay.com PJ Placement Page 1 of 2
Ceiling Mounted Installation
This is a reference to compare placement between the different models.
The ability to hang a projector higher is usually desired;
this drawing allows you to see the height each model needs to be mounted at for a 100" screen.
All the projectors are placed at the proper height (using 100" screen) and are within the zoom range for that lens.
Note: All projectors shown at the middle point of their respective zoom range.
WT610E
Ceiling
100" Diagonal Screen
Top
Center
Bottom
Orange = LT280/LT380
Green = VT49
w/Standard Lens
Lens shift
Lens shift
w/NP03ZL Lens
Color Chart
NP40
NP50
NP60
Red = VT490/VT590/VT595/VT695/VT700
NP08ZL
Lens shift
Blue = NP1000/NP2000/NP3150
Brown = NP4000/NP4001

NEC VT695 Specifications

General

Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	600:1
Projector native resolution	XGA (1024x768)
Focus	Manual
Throw ratio	1.5 - 1.8:1
Lamp power	200 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Dimensions (WxDxH)	309 x 258 x 112 mm
Power requirements	100 - 240 VAC, 50/60Hz
Connectivity technology	Wired
Noise level	35 dB
Power consumption (typical)	280 W
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	5 - 40 °C
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Weight	2900 g