NEC VT695 Control Commands

======================================================================
Control Commands for NEC Projector (Basic) Rev 3.0.30f
Copyright (C) NEC Viewtechnology, Ltd. 2002-2006
----------------------------------------------------------------------
Updated on November 09, 2007
----------------------------------------------------------------------
This file contains information about NEC projector control commands.
Model
Name
GT60 : GT5000/GT6000 Series
HT : HT1000/HT1100 Series
HT10 : HT410/HT510 Series
LT : LT180
LT30 : LT25/LT30/LT35 Series
NP40 : NP40/NP50/NP60 Series
LT60 : LT220/LT240/LT240K/LT260/LT260K/LT245/LT265 Series
LT80 : LT280/LT380 Series
MT70 : MT860/MT1060/MT1065/MT1075 Series
NP1000 : NP1000/NP2000/NP1150/NP2150/NP3150 Series
WT : WT600/WT610/WT615 Series
VT : VT770 Series
VT70 : VT37/VT47/VT480/VT57/VT570/VT575/VT670/VT676 Series
VT80 : VT48/VT480/VT580 Series
VT90 : VT49/VT490/VT590/VT595/VT695/VT700 Series
NP4000 : NP4000/NP4001 Series
======================================================================
Contents
1. Projector Control
2. Connection Method
3. Interface Conditions
4. List of Commands
5. Command Descriptions
6. Table of Response Error Codes
======================================================================
1. Projector Control
----------------------------------------------------------------------
NEC projectors make use of control commands that control the functions of the projector via connection with
a personal computer or another device.
======================================================================
2. Connection Method
----------------------------------------------------------------------
The following 3 kinds of connection methods are available for sending and receiving control commands.
1. Serial connection using the serial port on the projector
A serial cable is required.

NEC VT695 Specifications

General

Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	600:1
Projector native resolution	XGA (1024x768)
Focus	Manual
Throw ratio	1.5 - 1.8:1
Lamp power	200 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Dimensions (WxDxH)	309 x 258 x 112 mm
Power requirements	100 - 240 VAC, 50/60Hz
Connectivity technology	Wired
Noise level	35 dB
Power consumption (typical)	280 W
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	5 - 40 °C
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Weight	2900 g