Necta SINFONIA GF6 - Maintenance; Removing and Installing the Bucket

Instructions
for Installer,
Maintenance Engineer
and final User
SINFONIA
Rev. 00
H4345 - 00 02/2013 Page 28 of 41
7.3 Removing and Installing the Bucket
BEFORE STARTING THE VENDING MACHINE DISCONNECT FROM THE POWER SUPPLY
Check the position
To re
-
install, please
follow
the
previous instructions
backwards
1. Connect the harness on the left side of the bucket
2. Place the bucket on the moving part and push until it locks into place.
3. Fix with the screws which are removed before.
1. Move the bucket to the middle with caution.
2. Remove the two screws.
3. Put your finger under the bucket
and unhook the hook and lift it up.
4. Remove the harness on the left
side of the bucket