Instructions
for Installer,
Maintenance Engineer
and final User
SINFONIA
Rev. 00
H4345 - 00 02/2013 Page 3 of 41
1 GENERAL INFORMATION
1.1 Purpose of Manual
The manual contains the correct procedures for loading, usage, regular and extra-ordinary maintenance and
i
n
stallation of vending machines. This manual is a very important part of the vendor and therefore must be
kept intact and available for the whole productive life of the vendor .
KEEP INSIDE THE MACHINE
1.2 Interested people
This manual is for the persons in charge of loading, cleaning and ordinary maintenance of the machine.
(Lo
ading Operator), the final user (User)) and the people involved in installing
, setting, extraordinary
maintenance of the vendor (Installer/Maintenance Technician). The persons in charge must know the
instructions and comply with the procedure of the manual.
Technicians allowed to operate one this vending machines
Operator (person who only loads the machine with products to be sold)
o The operator can only load products to be sold in the vending machine.
o Doing this operation the operator should never move the protective lower carter as indicated
on the related safety icon-label on the protection.
Maintenance Engineer / Skilled technician
o In order to perform all the operations requiring to dismount the protective lower carte, it is
necessary to contact only SandenVendo technicians or only authorized (by SandenVendo)
skilled and prepared technicians due to the potential electrical and mechanical risks.
The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction. Children being
supervised not to play with the appliance. Instructions state that access to the service area is restricted to
persons having safety/hygiene knowledge and practical experience of the appliance (IEC 60335-2-75).
1.3 Responsibility
The responsibility of the manufacturer is limited to the correct usage of the vendor
“SandenVendo Europe S.p.A” declines any responsibility for possible damages caused to people and/or
things as a result of:
- Incorrect installation.
- Usage of unoriginal spare parts.
- Unforeseen modifications/authorized by manufacturer.
- Improper use of vendor
- Connection to inadeguate supply system and not in conformity with the regulations in force
1.4 Manufacturer
“SandenVendo Europe S.p.A.”
claims more than 20 years of experience in the manufacturing of Vending
machines, and it is the technical know-how acquired, after years of researches and close contact with the
production and commercialisation at global level that represents the best warranty SandenVendo Europe
S.p.A. can offer
SandenVendo Europe S.p.A.
SandenVendo Europe S.p.A.SandenVendo Europe S.p.A.
SandenVendo Europe S.p.A.
Strada Statale Casale Torino km 4
15030 Coniolo (AL) - ITALIA
Tel.: +39 0142 335111 – Fax: +39 0142 562348
e-mail: infosve@sandenvendo.com
website: www.sandenvendo.com
1.5 Service Centres
N&W GLOBAL VENDING S. p. A.
Via Roma 24
24030 Valbrembo
Italy - Tel. +39 035606111
To Next Page
Loading...
