9 10 11 12 13
Clearing the chamber
Vaping temperature for extracts
Adding extracts into the capsule
Operating Guide: Vaping Extracts*
01
02
03
If recently used, allow your device to cool down then clean it out
using the MagStick and/or a brush to ensure the chamber is free
of any loose leaf and/or resin. Place the provided extract/concen-
trate/wax pad into the chamber.
Place a small amount of extract onto the pad, roughly the size of
a half a pea & gradually increase to the size of a pea to find your
preferred amount. See next page for more info.
Note: When using extract dosing capsules, remove the resin trap as
this maximises the utilisation of the extract.
Extracts tend to have a higher boiling point than dry herbs so set
the temperature of your device to 230°C-240°C. Once your device
vibrates, wait an additional 20s and then take long, slow and
smooth tokes (each toke should last between 5-10s depending on
how strong you desire the hit to be).
*NOTE: To vape extracts you should use an extract dosing capsule to avoid clogging your
device. Please see page 11 for more instructions when using extract dosing capsules.
To Next Page
Loading...
