Nectar move NECFL03 - Lift Function Issues; Tandem System Synchronization

17
•
Check the baeries in the remote control. Replace
with new baeries, if necessary.
•
Make sure that you are following the du cycle
of the motors. Do not operate for more than two
minutes over a 20-minute period or approximately
10% du cycle.
•
Press the li buons rmly and accurately.
•
Wireless remote control may be experiencing
common radio frequency interference from other
radio transmiing devices. Wait several seconds
and then try pressing the li buons again.
Head or foot li funcon has minor
interference during operaon.
This is normal. The li motors click when they are
engaged. No acon is required.
A clicking noise is heard under the bed
when raising or lowering the secons.
In the event the adjustable bed fails to operate, invesgate the symptoms and possible soluons below.
1. Remove any pin, nut, bolt, or white bushing one at a
me.
2. Lubricate it by applying the grease with a coon swab.
Using a lithium or spray lubricant is recommended.
(Lubricaon can be obtained by contacng
Customac's Customer Care Center).
3. When placing the lubricated pin, nut, bolt, or white
bushing back onto the adjustable bed, make sure there
is a looser ghtening on the nut.
4. Addional soluon: Aer compleng these steps,
spray the pins, nuts, bolts, and white bushings with a
lubricant.
The adjustable bed is squeaking.
1. Clear any cluer or obstrucons under and around
the adjustable bed. Radio frequency interference from
other remotes or electronic devices may aect normal
operaon.
2. Check the baeries in the remote.
3. Press the li buons on the remote control rmly and
accurately.
The adjustable bed stuers when in
moon.
Sync one remote to both adjustable beds. For more
informaon, see "Synchronizing two beds for tandem
operaon" on page 13.
Split or tandem system is out of sync. Only
one of the two adjustable bed raises or
both beds raise but one side is higher than
the other.
SYMPTOM SOLUTIONS
Troubleshoong Guide