Nectar move NECFL03 - Installation Guide; Setting Up the Bed Frame; Attaching Support and Legs

7
NOTE: For safe reasons, liing of the adjustable bed must always be performed by two (2) people;
and the unit should always be on a at surface before opening.
Seing up your adjustable bed frame
1
2
Open the box and unfold the bed placing it on a at surface
with the top side facing downward.
Remove the accessory box and cut the orange es from inside
the bed frame.
Aaching the center support bracket
Move the three secons of the bed closer together. Make sure
the bars and frames are properly aligned at the center.
NOTE: King and Cal King beds have two secons only.
To connect the three secons, put the center support bracket
over the bars on one side of the bed frame, lining it up with the
pre-drilled holes.
Thread 4 big knob screws ed with spring washers into the
pre-drilled holes on the bracket and through the bed frame.
Keep the screws loose for now.
NOTE: Make sure all the screws t and align with the bracket
properly. Do not ghten the screws yet.
1
2
3
Installaon Guide