Nectar move NECFL03 - Tandem Operation and Reset; Special Functions

14
Remote Control Guide
Synchronizing two beds for tandem operaon
To operate two adjustable beds simultaneously, you must connect both beds using the sync cable.
Plug both Bed A and Bed B to working electrical outlets. A surge
protector is recommended.
Press the FLAT buon on Remote A and Remote B to align the
beds properly in a at posion.
Plug one end of the sync cable to the control box on Bed A. Insert
it into the port labeled "SYNC."
Plug the other end of the sync cable to the control box on Bed B.
Insert it into the port labeled "SYNC"
Bed A and Bed B can now be controlled simultaneously using
Remote A or Remote B.
NOTE: When operang beds in tandem, both beds should always
be plugged into working electrical outlets.
1
2
3
4
Reseing your system
Reseing the system is somemes necessary to restore any customizaon on the preset buons to its factory seings.
On the remote control, press and hold the Lounge
and ZG
buons at the same me unl the remote backlight ashes.
All customized seings on the remote control and control box are
now cleared or returned to their factory default seings.
The convenient USB ports located on each side of your adjustable
bed provide easy access for charging your tech devices.
Using the mounted USB ports
Special Funcons