16
In the event the adjustable bed fails to operate, invesgate the symptoms and possible soluons below.
SYMPTOM SOLUTIONS
•
Your adjustable bed may be obstructed prevenng
smooth operaon. Remove obstrucons from
around and under the bed.
•
Check that the head secon is not too close to the
wall.
•
If a headboard is installed, check that it is not
too close to the edge of the maress. Make sure
there is enough distance between the headboard
bracket and the maress.
Head or foot secon elevates adjustable
bed but does not return to at posion.
Troubleshoong Guide
•
Check that the power cord is plugged into a working
electrical outlet. Unplug the power cord from the outlet.
Aer 30 seconds, plug it back in. Press any buon on
the remote control and check if the bed responds.
•
Check if the control box is working properly. Make sure
the control box is properly connected to the power
supply unit by checking if the LED light turns on when
the power cord is plugged in.
•
Check the baeries in the remote control. Replace with
new baeries, if necessary.
•
Make sure baeries are properly installed. Follow the
markings on the baery compartment.
•
Remove baeries. Leave them out for 30 seconds
before puing them back into the remote control.
•
Scratch the terminals inside the remote's baery
compartment with a coin or key.
•
Check that the surge protecon device or electrical
outlet is not defecve. Test the outlet by plugging in
another working appliance.
The adjustable bed does not respond
when the remote is used. The remote
does not work.
•
Make sure the remote control is paired with the
adjustable bed.
•
Check that the power cord is plugged into a working
electrical outlet. Unplug the power cord from the outlet.
Aer 30 seconds, plug it back in. Press any buon on
the remote control and check if the bed responds.
•
Check that the surge protecon device or electrical
outlet is not defecve. Test the outlet by plugging in
another working appliance.
No features or funcon of the adjustable
bed acvates.