VP5002-300PM-00GB-V-Scan Manual version 2.7 / Page 16
11. From now on the Bluetooth Serial Connection with the V-Scan is set up.
After the setup, the Bluetooth connection will be established automatically. Steps to proceed:
1. Switch on the V-Scan
2. Start the V-Scan Data Manager / V-Scan – Velos synchronisation application.
3. The connection will be established automatically.
When the V-Scan switches off (automatically), the communication will be lost. It takes
some time (> 5 seconds) before the V-Scan Application gets the “no connection
signal” from the Bluetooth Serial Port. Also when the V-Scan is switched on again, it
takes some time before the communication is established again.
To Next Page
Loading...
