Nedap WIM - Introduction to WIM Installation; Key Features of the WIM

WIM | QUICK REFERENCE GUIDE
3/4
CONNECTIONS
Front side
RS485 Connect the RS485 to the License Plate Reader (9600, 8N1).
B: RS485-B (green)
A: RS485-A (yellow)
GND: RS485-GND (purple)
Wiegand Connect the Wiegand output to your access control system.
D1: Wiegand data-1 (white)
D0: Wiegand data-0 (green)
GND: Ground (black)
Magstripe Magstripe Clock and Data output. Select with the plate conversion mode switches. See below.
D1: Data
D0: Clock
CLS: Card Loaded
GND: Ground
Barcode Barcode wand emulation data output in code39 format. Select with conversion mode
switches. See below.
D1: Wand emulation data output (black=high)
D0: Wand emulation data output (black=low)
GND: Ground (black)
STS LED
Status LED (green)
ERR LED
Error LED (red)
LAN The LAN connection (RJ45 socket) is used to configure the device and manage the match-list.
Link LED (left): Off=No link, Amber=10Mbps,
Green=100Mbps.
Activity LED (right): Off=No activity, Amber=HDX Activity,
Green=FDX Activity.
RS485
connection
WIEGAND
output
LED
indications
LAN
connection
GND CLS D0
D1
GND A
B