Need help?Do you have a question about the Nedap WIM and is the answer not in the manual?
General| Brand | Nedap |
|---|---|
| Model | WIM |
| Category | Control Unit |
| Language | English |
Lists the main functionalities and capabilities of the WIM module.
Outlines essential safety measures for device installation and operation.
Provides the physical size specifications of the WIM unit.
Details the RS485 connection for the License Plate Reader.
Explains the Wiegand output connection to an access control system.
Describes the Magstripe output connection for data and clock signals.
Details the Barcode wand emulation output connection.
Explains the function of the Status (STS) and Error (ERR) LEDs.
Details the LAN connection for configuration and management.
Specifies the power supply requirements and connection.
Explains the function of the DIP-switches for mode selection.
Configures settings for the License Plate Reader via web browser.
Configures OCR Read, Not Read, and No Plate events with RS485 messages.
Configures system-level settings for the WIM.
Configures the RS485 serial port parameters like baud rate.
Converts license plates to Wiegand 26-bit using SHA-1 hashing.
Converts license plates to a Wiegand 64-bit output message.
Converts license plates to Magstripe ISO7811 track 1 format.
Converts license plates to Magstripe ISO7811 track 2 format.
Converts license plates to Barcode wand emulation code39 format.
Uses a match-list to determine Wiegand output for license plates.
Uses an extended match-list (XL) for Wiegand output.
Describes the ASCII format for command and response messages.
Lists and explains various command messages for device control.
Command to request the firmware version of the WIM.
Command to request the currently selected plate conversion mode.
Command to request the status of the match-list.
Command to clear the device's match-list entries.
Command to add or update an entry in the match-list.
Command to retrieve a specific entry from the match-list.
Command to set the Wiegand output for unmatched license plates.
Command to request the no-match-found entry configuration.
Command to clear the no-match-found entry.
Physical size specifications of the WIM unit.
IP rating, operating temperature, and humidity limits.
Specifies power supply voltage, current, and consumption.
Details communication interfaces and match-list capacities.
To Next Page
