Appliance door en
31
20.2 Attaching the appliance door
1.
Tip:Ensure that the appliance door is not wedged
at an angle and that it is properly fitted in place.
Attach the appliance door via the left- and right-hand
guide rollers simultaneously .
2.
Rotate the door handle upwards slightly .
a The appliance door slides the short distance re-
maining to the bottom .
3.
Use a coin to release both locks on the appliance
door. Insert the coin in the gap in the lock and ro-
tate as far as it will go .
‒ Turn the lock on the left-hand side in an anti-
clockwise direction.
‒ Turn the lock on the right-hand side in a clock-
wise direction.
4.
Open the appliance door slightly until you hear a
quiet click, and then close the appliance door.
5.
WARNING‒Risk of injury!
If the door locks are unsecured, the appliance door
may become detached.
▶
After attaching the appliance door, close the left-
and right-hand door locks.
Hold the screwdriver horizontally and use it to
push the door lock (black component) on each side
of the door downwards as far as it will go .
a The door lock is closed.
20.3 Removing the door panes
To facilitate cleaning, you can remove the door pane.
WARNING‒Risk of injury!
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
Requirement:The appliance door is detached.
1.
Lay the appliance door with the front side facing
down on a flat surface that is soft and clean.
2.
Push on the left- and right-hand side of the appli-
ance door from the outside until the inner pane is
released on both sides.
3.
Carefully lift the inner pane and remove it in the dir-
ection of the arrow .
To Next Page
Loading...
Need help?
General
