56
en Care and daily cleaning
Cleaning the milk system
The milk system is automatically cleaned
with a short jet of steam directly after pre-
paring a milk drink.
F
Tip: For particularly thorough clean-
ing, the milk system can be addi-
tionally rinsed with water (see the
section “Rinsing the milk system”).
Important: Clean the milk system
manually every week and, if
required, also more often (see the
section “Cleaning the milk system
manually”).
B
Risk of burns!
The beverage outlet gets very hot.
After use, always let it cool down
before you touch it.
Rinsing the milk system
■ Touch E and select K or L
“Rinse milk system” with the arrow button.
■ Press the M arrow button. The pro-
gramme starts.
■ Open door and remove suction pipe from
the milk tube.
■ Wipe the suction pipe and insert the end
of the suction pipe into the hole on the
coffee grounds container.
■ Close the door. Be careful not to jam the
milk tube.
■ Place an empty glass underneath the
beverage outlet.
■ Touch C.
The milk system is rinsed with water.
■ Then empty the glass.
■ Touch E to exit the programme.
The milk system has finished rinsing. The
appliance is ready for use again.
Cleaning the milk system manually
Take the milk system apart to clean it:
■ Push the beverage outlet down com-
pletely and pull the cover forward to
remove.
■ Press the snap lever to the left of the
beverage outlet downwards and pull the
beverage outlet forward.
■ Remove the milk tube. Dismantle the top
and bottom sections of the beverage outlet.
■ Separate the milk tubes, connecting
element and suction pipe.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
