NEFF C77V60N2 - Dispensing Hot Water; Preparing Milk Froth and Warm Milk

Neff C77V60N2 | 02/2012
46 | English
The changes you have made are
saved automatically. It is not neces-
sary to conrm them additionally.
Preparingmilkfrothandwarm
milk
Riskofburns!
Themilkfrother(19)getsvery
hot.Afteruse,allowtocooldown
rstbeforetouching.
For optimal milk froth, use cold milk
with a fat content of at least 1.5 % if
possible.
1. Take the milk tube (12) and connect it to
the milk frother (19)
(see “Preparation using milk”).
2. Place a cup or glass under the outlet of
the milk frother.
3. Select the required setting for
Milk froth
or
Warm milk with the navigation button
(4):
My coffee Milk froth Warm milk
4. Press z (6).
Milk froth or warm milk runs out of the milk
frother outlet (takes about 40 or 60 seconds
respectively).
Press z (6) again to cut the process short.
The appliance may make a whistling
noise when warm milk is being
prepared. This is caused by the milk
frother (19) for technical reasons.
Dried milk residue is difcult to
remove, so clean the milk frother
immediately after use (see
“ Cleaning the milk system”).
Dispensinghotwater
Riskofburns!
Themilkfrother(19),fromwhich
thehotwaterows,getsveryhot.
Afteruse,allowtocooldownrstbefore
touching.
The appliance can also be used to dispense
hot water, e.g. for tea.
1. Place a cup or glass under the coffee
outlet.
2. Select Hot water with the navigation
button
(4):
Warm milk Hot water Short rinse
∼ 85ºC
3. Press Z (5) to switch to the temperature
selection. Set the required temperature
with the navigation button
(4):
Hot water
∼ 80ºC
∼ 85ºC ∼ 90ºC
4. Press z (6).
Hot water runs out of the milk frother outlet
for about 40 seconds.
Press z (6) again to cut the process short.
Warm up cups before use,
especially small, thick espresso
cups, with the hot water.