NEFF I95CBS8W0 Series User Manual

Familiarising yourself with your appliance en
7
5 Familiarising yourself with your appliance
5.1 Controls
You can use the control panel to configure all functions
of your appliance and to obtain information about the
operating status.
Tip:Align the remote control as precisely as possible
to the infrared receiver for the LED display.
Switch the appliance on or off
Switching automatic mode
1
on or off
Increase the fan setting
Decrease the fan setting
Switch the lighting on or off
Reduce the brightness
Increase the brightness
1
Depending on the appliance specifications
Switch the fan run-on on or off
HomeConnect
Reset the filter saturation indicator
1
Depending on the appliance specifications
5.2 LED display
Die LED-Anzeige zeigt eingestellte Werte und Funk-
tionen.
81 2 3 4 5 6 7
1
Fan setting 1/grease filter saturation display
2
Fan setting 2/odour filter saturation indicator
3
Fan setting 3
4
Intensive mode 1
5
Intensive mode 2
6
Automatic mode
1
/fan run-on time/interval vent-
ilation
7
HomeConnect
8
Infrared receiver
1
Depending on the appliance specifications
6 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
6.1 Setting an operating mode
Your appliance is set to air extraction mode by default.
To use it in circulating-air mode, you must set the oper-
ating mode.
Note:For use in circulating-air mode, you require addi-
tional Accessories.
Requirement:The appliance is switched off.
1.
Press and hold ⁠and ⁠for approx.three seconds.
‒ To set circulating-air mode (non-regenerable fil-
ter), press ⁠/ ⁠ until LED2 lights up in the LED
display.
‒ To set circulating-air mode (non-regenerable fil-
ter), press ⁠/ ⁠ until LED3 lights up in the LED
display.
‒ To convert the electronic control back to opera-
tion without the air recirculation filter, press ⁠/ ⁠
until LED1 lights up on the LED display.
2.
To save the setting, press and hold ⁠and ⁠for ap-
prox. three seconds.
Or wait approx. 10seconds until the setting is
saved automatically.
To cancel the setting, press ⁠.
a A signal tone sounds as soon as the selected set-
ting is saved.
7 Basic operation
7.1 Switching on the appliance
Requirement:Align the remote control as precisely as
possible to the infrared receiver for the LED display.
▶
Press ⁠ to switch on the appliance.
a The appliance starts at fan setting2.
a The LED for the set fan setting lights up in the LED
display.

NEFF I95CBS8W0 Series Specifications

General

Brand	NEFF
Model	I95CBS8W0 Series
Category	Ventilation Hood
Language	English