en Basic settings
16
4.
Once the time has elapsed, the display shows the
time as zero. The appliance stops heating up and
responds again as usual outside of Sabbath mode.
‒ Switch off the appliance.
The appliance automatically switches off after ap-
prox.10to 20 minutes.
13 Basic settings
You can configure the basic settings for your appliance to meet your needs.
13.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Display Basic setting Selection
Automatic childproof lock
→"Childproof lock", Page15
= no
1
= yes
Signal duration upon completion of a cook-
ing time or timer period
= 10 seconds
= 30 seconds
1
= 2 minutes
Waiting time until a setting is adopted = 3 seconds
1
= 6 seconds
= 10 seconds
Button tone when pressing a button = off
= on
1
Brightness of the display illumination = dark
= medium
1
= bright
Time display = hide the time
= display the time
1
Childproof lock can be adjusted
→"Childproof lock", Page15
= no
= yes
1
= yes, with locked door
Interior lighting during operation = no
= yes
1
Cooling fan run-on time = short
= medium
1
= long
= extra long
Telescopic shelves retrofitted
2, 3
= no
1
(for rails and 1-level pull-out)
= yes (for 2- and 3-level pull-out)
Sabbath mode available
3
→"Sabbath mode", Page15
= no
1
= yes
Automatic rapid heating from 200°C
2
= no
= yes
1
Reset all values to factory settings = no
1
= yes
.. HomeConnect Settings
→"HomeConnect ", Page17
1
Factory setting (may vary according to model)
2
Depending on the appliance specifications
3
Bottom oven
13.2 Changing basic settings
Requirement:The appliance is switched off.
1.
Press and hold the button for approximately
fourseconds.
a The first basic setting appears in the display,
e.g. .
2.
Use the temperature selector to change the setting.
3.
Use the or button to switch to the next basic set-
ting.
4.
To save the changes, press and hold the button
for approx. fourseconds.
Note:Your changes to the basic settings will be re-
tained even after a power failure.
To Next Page
Loading...
Need help?
General
