3 / 13
Do not illuminate the patient’s eye for more than 1 minute per eye and be
sure to keep illumination at minimal intensity needed to view the fundus.
Use of accessories other than those specified or provided by the
manufacturer of this equipment could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this equipment and
result in improper operation.
Do not apply strong force to the device or handle it roughly. Doing so may
result in injury or device failure.
Do not use in excessively humid or saline environments, or places where the
device may be sprayed with water. Doing so may result in electric shock or
Do not expose the device to direct sunlight or harmful radiation. Doing so
may lead to unexpected heating and result in device failure.
Do not sterilize.
Do not use paint thinners, cleaning agents or boiling water to clean the
device. Doing so may cause deformation or device failure.
Do not immerse in cleaning detergents or rinse with water. Doing so may
cause device failure.
Do not use the BXα-13 or BXα-13A adjacent to or stacked with other
equipment. In cases where adjacent or stacked use is necessary, verify the
BXα-13 or BXα-13A operates normally prior to use.
Portable RF communications equipment (including peripherals such as
antenna cables and external antennas) should be used no closer than 30 cm
(12 inches) to any part of the BXα-13 or BXα-13A. Otherwise, degradation of
the performance of this equipment could result.
Be sure the head and handle are attached firmly before use.
Use only alkaline dry-cell batteries.
When replacing batteries, replace both cells at the same time using identical
batteries.
Remove batteries from the device during prolonged periods of disuse.
Allow the device to return to room temperature before unpacking. Not doing
so may cause condensation and lead to device failure.
Make sure the illumination is turned off during transport or storage and only
use the specified casing. Failure to do so may result in deformation, device
To Next Page
Loading...