NEJE E80 User Manual

Compatibility
Compatible with NEJE 3 Max (the motherboard model is higher than V1.1), only need to
update the 24V power supply, the relay and valve control module are compatible, the
temperature will be higher than in 12V mode, and there is no problem with indirect use. It is
recommended to connect other devices through the control board, and it is recommended
to use the device with Z-axis control, which is conducive to the full performance of the E80.
Maintenance
Although this module adopts internal air-assisted design, long-term use may not prevent
dust or a small amount of smoke from affecting the lens. It is recommended to clean the
lens with a clean cotton swab. Dust or smoke may overheat the lens and cause the lens to
burn out. Re-acquire the lens Will delay your use.

NEJE E80 Specifications

General

Input Voltage	DC 12V
PWM/TTL Input	TTL
Adapter plug	5.5mm x 2.1mm
Laser Power	10W
Supported Materials	Wood, Leather, Paper
Connection	USB
Software Compatibility	LightBurn, LaserGRBL
Operating System Compatibility	Windows, macOS, Linux