Laser & Material Database
Max Cutting depth < 30mm.
Typical Material Parameters：
17mm Pine Board with NEJE Max 4
Speed (mm/min): 300
Max Power (%): 100
Air Assist: ON
Number of Passes: 3 (2.5)
Z Offset (mm):(The distance between the module and the surface of the board)-Focal
length(25mm) +4mm
Z step per pass (mm): 1.5
10mm BIRCH PLYWOOD With NEJE Max 4
Speed (mm/min): 500
Max Power (%): 100
Air Assist: ON
Number of Passes: 2
Z Offset (mm): (The distance between the module and the surface of the board)-Focal
length(25mm)
Z step per pass (mm): 2
3mm mdf board With NEJE Max 4
Speed (mm/min): 650
Max Power (%): 100
Air Assist: ON
Number of Passes: 1
Z Offset (mm): (The distance between the module and the surface of the board)-Focal
length(25mm)
To Next Page
Loading...