www.nektartech.com Nektar Aura Cubase Integration 1
Setup
Here are the steps you need to go through to get Cubase up and running with Aura::
• Make sure Cubase is already installed on your computer. If not, please install and run it at least once and quit Cubase again.
• Run the Aura_Steinberg_Support installer, included in the package along with this PDF guide..
• Connect Aura to your computer or a powered USB hub connected to your computer and make sure it‘s switched on.
• Launch Cubase.
• In Cubase go to Studio/Studio Setup and select MIDI Port Setup.
• Untick all of the ports in the ‘In ‘All MIDI Inputs‘‘ column except for
- macOS: ‘AURA Internal‘
- Windows: ‘AURA‘.
The ports should now look similar to the image below.
• Click ‘OK‘ to close the Studio Setup window.
That’s it, setup is now complete and Aura should be communicating with Cubase.
Nektar Aura: Cubase Setup and User Guide