www.nektartech.com Nektar SE25 & SE49 DAW Integration User Guide 1
To get your SE25/49 working with your DAW, locate the instructions for your DAW on the following pages and complete Installation &
Setup.
With Nektar DAW Integration installed, here is how your Nektar product works with your DAW.
SE25/SE49 provide instant access to transport controls as well as track or patch change in your DAW, using the 4 buttons with the trans-
port icons
ASSIGNING THE REWIND/FORWARD BUTTONS TO CONTROL TRACK OR PATCH NAVIGATION
• Press the two buttons labelled [Setup] on your SE25/SE49. The Setup menu is now active.
• On the keyboard, press the key with the [Track] label above (SE25: C#2, SE49: D#2).
• Press the top C labelled Enter to confirm selection and exit Setup. (Note: on SE25, this step is not needed).
The [Rewind] button now navigate to previous track and the [Forward] button navigate to next track.
To assign the buttons to control your DAWs patch changes, follow the same steps, replacing the Track key with the one labelled Patch.
* Note: In FL Studio, [Track] navigates the mixer track and [Patch] navigates the Channel.
TRANSPORT CONTROL
• Press the [Play] + [Rewind] buttons (the two buttons on the left) on your SE25/SE49 at the same time to assign the 4 buttons to trans-
port functions.
• Each of the buttons now control transport functions according to their label: Play, Record, Rewind and Forward.
• Press [Play] + [Rewind] again to exit transport control.
CONTROLLING VOLUME (SE49 only)
The SE49 fader control is assigned to control volume of the currently selected track.
Move the fader all the way up and down. The mixer volume for the currently selected track is now controlled by the fader.
Nektar DAW Integration and SE25/SE49 Working Together
SE25 / SE49
To Next Page
Need help?
General
