RUDDER CROSSPIECE
It’s where the rudder cables are aached
wich makes it possible for the rudder to tun.
It gives a sensive, smoother control thanks
to the new design.
RUDDER ( Sete | Marathon )
It allows you to turn the boat.
Sete Rudder (6mm)
100% carbon. Ideal for sprint use.
Marathon Rudder (6mm) -
Specic for marathon. 100% Nylon
for impact resistance.
How it works
1 - Insert the rudder through the hole in the
hull.
2 - Insert the sha into the crosspiece hole.
The arrow on the crosspiece should point forwards.
3 - It only ts in one way, so don’t worry if
it’s ok. It will be.
4 - Tighten the rudder crosspiece screw.
NUMBER HOLDER
This is where you place the compeon
number or lane number. It is made of 100%
plasc and xed only with two simple nuts.
How it works
1 - Right and le rudder cables are aached
to it with knots.
2 - Rudder enters in the one way channel and it’s
ghtened with a simple screw.
How to replace
1- Remove old Number Holder from your boat unscrewing
old screws.
2 - Put the new Number Holder at the same place and
ghten the new nuts.
4. FITTINGS
To Next Page
Loading...