Nemaxx P9 - Timer Setting; Language Setting

21
Version: 9a
13.11.2018
EN
TIMER SETTING
Begin as described on page 18.
Press
until the following message appears:
LANGUAGE SETTING
Begin as described on page 18.
Press
until the following message appears:
With this function you can select the language. By pressing the key
To sav e t h e setti n g p r e ss and enter the next setting.
With this function you program the heater for a weekly programming, associating the switching on and the
switching o󰀨 at the pre xed timetables.
You can program daily switching on and switching o󰀨 for the whole week.
By keeping the key pushed
you will nd the attached instruction above,
then you can press
to choose week days.
By pressing select hours, then press
to choose the time for turning on or o󰀨.
On the above line the day is shown when it is programmed, the hour with the functioning cycle.
On the below line the programmed hour is displayed.
- The lower one is o󰀨, higher one is on, which also shows on the superior line
To sav e t h e setti n g p r e ss
and enter the next setting.