_ _ _ _ * * 0 # (not bypassed)
Use this feature to prevent the alarm from sounding when a service condition exists.
A service condition may occur for a short duration after a prolonged mains power failure.
If however the service condition persists, it could be that the battery needs replacing or
some other element of the energizer or fence installation needs servicing. Please call your
installer. If your installer has programmed their contact number into the energizer, and
enabled this feature, the number will be displayed during a service condition.
No symbol exists on the keypad or energizer to indicate that this function is active. Enable
or disable this function as needed.
PANIC ALARM 9 1 #
Use this feature to manually trigger an alarm in an emergency.
No PIN is required.
CHANGING A USER PIN _ _ _ _ * 0 ? # (start change user PIN)
_ _ _ _ # (enter new PIN)
_ _ _ _ # (confirm new PIN)
To change a user PIN requires three key code sequences in succession.
Depending on which PIN is being changed, either a 1 (master user) or a 2 (reset user)
should be placed in the position indicated by the ? above. Following the first start change
user PIN sequence, a new four digit PIN should be entered followed by the # key. The
same four digit PIN should be entered a second time, followed by the # key to confirm
and complete the PIN change sequence. If successful, the new pin will be confirmed with
two beeps. If the process fails, a single long beep will be heard, in which case the process
should be started again from the beginning. If however you are aware that you made a
mistake in entering the PIN the second time, simply re-enter the PIN correctly a third time
and listen for confirmation or failure as described.
To Next Page
Loading...
