neno primo - Troubleshooting and Storage; Frequently Asked Questions (FAQ); Long-Term Storage; Cleaning Instructions

12
10. FAQ
1. The machine does not start: ensure that the breast pump is connected to a working
electrical outlet. If the breast pump has no power source, its display will not turn on and
no error message will appear.
2. No/ poor sucon: make sure all parts of the breast pump are correctly posioned.
Disassemble the breast pump and make sure that all parts are clean and undamaged.
Assemble the breast pump again according to the instrucons in secon „Assembling the
breast pump”.
3. More milk has flowed out of the breast than the bole can hold: switch off the breast
pump and unplug it. Use a damp (not wet) cloth to wipe the breast pump. When all parts
of the device are dry, reassemble them.
Expression mode - slower pumping which gently and efficiently sucks breast milk.
c. In the expression mode, increase the sucon power unl you feel slight discomfort
(not pain) and reduce the sucon power by one degree.
11. LONG-TERM STORAGE
1. The breast pump has a built-in baery. To protect against damage, the device goes into
storage mode aer a long period of inacvity. To turn off storage mode, connect the device
to power and charge it for 2 hours.
2. Before pung the breast pump away for a longer period of me, make sure that:
a. All parts of the breast pump are clean.
b. You have cleaned the pumping device.
c. The device's baery is fully charged.
12. CLEANING INSTRUCTIONS
Prepare: mild soap or other cleaning agent, clean dish towel, drinking-quality water.
Parts that need to be washed or disinfected:
- Breast shield,
- Milk bole,
- Connector,
- Valve,
- Sucon cup,
- Sucon bowl,
- Breast shield dust cap.
WARNING:
- Wash all parts that have had direct contact with breast milk immediately aer use. This
helps you will avoid residue and the growth of bacteria in the device.
- Use only drinking-quality water (tap or boled) to clean the appliance.
- When cleaning valves, do not use small instruments such as brushes. Be careful not to pierce
the part.
- Disassemble, wash and rinse all parts of the device that have come into direct contact with
breast milk (except for the pump).