24
Avalon Matrix Switch User’s Guide (document number 42-00001-A)
The serial port will not echo characters back to the sender. Instead
once the command is completed, the response will be sent back as
shown in the Query section below, and depending on the verbosity
settings.
Setup and Misc commands
The following commands are stored in EEPROM memory, so they
will still be set after a power outage.
[S,a,n]
S = Setup function
a=function letter, n=argument
L=lights on the front panel
0=blackout
1=normal state (default)
R=Front IR receiver
0=disabled
1=enabled (default)
B=Front panel buttons
0=disabled
1=enabled (default)
V=Verbosity
0=respond only when sent a command
1=any change in state from front, IR, or other ports
are sent out like queries (default)
[P,n]
P=power control
To Next Page
Loading...
Need help?
General