Waterproof case:
*Keep the rubber seal clean, as even if a single hair or grain of sand can cause a water leak. It is the best to clean
it with non-dust cloth.
*After every use in salt water, you will need to rinse the outside of the housing with fresh water and then dry.
Failure to do so can eventually cause corrosion of the hinge pin and salt buildup in the seal, which can cause
failure.
*Please try not to remove or reset the seal. It may cause leaks and damage your camera.
Adhesive mounts:
*Clean the attachment surface first. Wax, oil, dirt and other debris will reduce adhesion which can result in a weak
bond which may result in loss of your camera.
*Only attach a mount in room temperature conditions, It may not bond well in very cold or damp environments.
*The adhesive mounts can only be mounted to a smooth surface.
*For best results, please attach your mount at a minimum of 24 hrs before use.
3
To Next Page
Loading...
Need help?
General