Neol ePowerSwitch 8M+R2 - Page 45

44
2. Timer Rule:
This rule can be used to trigger user-specified actions according to a defined time table.
This rule can be used to switch On or Off a power outlet (or a group of power outlets) or a digital output at
specified time and weekday(s) for a specified time. You must define the start time, the weekday(s) and the
stop time.
Example:
- The rule could be used to switch On a device every Monday and Friday from 8:00 AM (Start Time) and
switch it automatically off every Monday and Friday at 05:00 PM (Stop Time)
3. Ping Monitoring Rule:
This rule is used to control actions according to the response to a Ping command.
This rule can be used to check if a computer or any IP device is connected to the network. If the host
doesn't reply, the ePowerSwitch 8M+
R2
can automatically restart the powered device.
4. Scan Monitoring Rule:
This rule is used to control actions according to the response to a Scan command.
This rule can be used to check if a specific protocol is available on a. If the connection is not possible,
ePowerSwitch 8M+
R2
can automatically restart the powered device.
5. Power Supply Monitoring Rule:
This rule is used to control actions according to the state of the power supplies of the ePowerSwitch
8M+
R2
and its peripherals like the ePowerSwitch 8XS and the Digital Input Module.
6. Digital Input Monitoring Rule:
This rule is used to control actions according to the state of a dry contact connected to a the Digital Input
Module, to a Digital Input Module, Proximity Sensor or a Push Button connected over the xBus to the
ePowerSwitch 8M+
R2
.
7. Analog Input Monitoring Rule:
This rule is used to control actions when an analog input (temperature, humidity, ambient light, current...)
exceeds a predefined value.