2.4 Mounting and dismounting the wheels:
18 mm open-ended spanner
AS A GENERAL RULE, NEVER OPERATE THE BRAKE LEVERS WHEN A WHEEL IS OFF THE BIKE.
T
HE WHEEL WILL BE VERY DIFFICULT TO REMOUNT SHOULD THIS HAPPEN.
2.4.1 Front wheel:
Dismounting the front wheel:
- Open and lightly turn the quick-release clamp.
Mounting the front wheel:
- Check the fastener tightness and alignment of the wheel.
- Once the wheel is in place, operate the brake handle 3-4 times. This allows the pads to settle correctly.
- Check that the brake disc is properly centred and rotates without friction.
- Finally, check that the wheel brakes are working properly.
2.4.2 Rear wheel:
Dismounting the rear wheel:
Disconnect the motor (the connector is situated on the right side of the e-bike on the lower horizontal section
of the frame).
Cut the Colson cable tie attaching the motor cable to the frame if necessary.
Remove the right and left wheel nut covers. Loosen the nuts. Remove the nuts and the wheel axel washers.
Move the wheel forward to remove it from the frame and remove the chain from the wheel axle.
Insert a piece of plastic in the calliper (between the two pads).
To Next Page
Loading...
