2.5.3 Front wheel (Kalyso Nuvinci model):
Dismounting the front wheel:
Undo the cap nuts on each side and remove the washers.
Raise the bike and tap lightly on the top of the tyre to remove the wheel.
Mounting the front wheel:
Reposition the washers on the wheel axle. Raise the bike and insert the wheel axle into the base of the
opening of the fork ends.
Check the position of the washers as well as the centring of the wheel. Screw in the wheel nuts.
Alternately and progressively tighten the wheel nuts on each side (max. tightening torque 25 Nm).
If the wheel is not centred, loosen the nuts and perform the operation again.
Do not adjust the locknuts, you may damage the bearings.
2.5.4 Rear wheel (Kalyso Nuvinci model):
This operation is to be carried out by a professional.
2.6 Lights:
Your bike is equipped with:
❖ Fixed front and rear lighting. The front and rear lights are powered by the battery. The lights are
switched on by pressing the + button on the controls for 1 second.
ALWAYS KEEP YOUR LIGHTS CLEAN AND IN GOOD CONDITION.
LIGHTS ARE OBLIGATORY AT NIGHT.
To Next Page
Loading...